Skip to content
Viking Pro Appliance Repair · Los Angeles
Call Book

Viking · Los Angeles

Viking panel-front dishwasher repair in Los Angeles

Fill, drain, leak and drying faults on Viking integrated and panel-front dishwashers, including heavy custom doors.

In one sentence

Viking dishwasher repair is fill, drain, leak and drying work on an integrated or panel-front machine — including the heavy custom doors that make one of these a different job from an ordinary dishwasher, because the door has to come back exactly as it went on.

Viking Pro Appliance Repair Los Angeles · (213) 516-4020

Dishwasher pump or control

$190–$410

The visit

$89 flat

Agreed with you before the work starts, and the $89 comes off it the moment you say yes. Every band on this site

Dishwasher drawn out of its cabinet with the lower panel off, exposing the circulation pump, sump and corrugated drain hose

On the phone

How people describe it

Four sentences we hear over and over, printed in the words they arrive in. Recognise one of them and the shortlist behind it is already short.

  1. Standing water left in the bottom when the cycle ends
  2. Cycle starts but the machine never takes on any water
  3. Water tracking out under the door and onto the floor
  4. Detergent still sitting in the cup after a full wash

Before you book

Worth a clean, or worth a call

Dishwasher Repair: the three we are rung about most, and which side of the line each one is on

What you are seeingWorth a clean firstWorth a callWhat waiting costs
A wet bottom at the end of a cycle The filter and the sump strainer lifted out, cleared and put back square, which is where most of these begin and end.It still leaves water with a clean filter, or it drains one cycle and not the next with no pattern to it.Water left standing goes stale between washes and the smell reaches the kitchen before the fault does.
A cycle that runs dry The supply tap under the sink checked as genuinely open, and the cycle restarted once from cold.It runs through as though it were washing, with nothing arriving, or it fills so slowly the cycle gives up.A pump asked to work on nothing is doing itself no good for as long as the cycle keeps being started.
A wet patch on the floor at the front The door seal wiped along its whole length and any trapped debris cleared out of the corners it collects in.It still escapes at the same spot, or the heavy custom front has begun to sit unevenly against the cabinet run.Water under a panel-front machine reaches the cabinet floor and the run either side of it before it is noticed.

In their words

What Los Angeles owners say afterwards

Left by Los Angeles owners once the work was finished.

5.0/ 51,210 reviews

  • The door dropped like a drawbridge whenever I opened it, heavy custom panel and all. A snapped spring cable on one side. He fitted both sides so they match, and it holds at any angle now.

    Oleta R.Encino

  • The machine would start its cycle and then sit there without taking any water. Sediment had blocked the strainer on the fill valve. He cleaned it, fitted a new valve, and ran a wash to prove it.

    Nadeem H.Larchmont Village

  • Detergent was still sitting in the cup at the end of every wash and nothing came out clean. The dispenser motor had failed. Replaced, and the glasses are clear again, but the part took a week to arrive.

    Sasha D.Larchmont Village

Book it

Dishwasher Repair in Los Angeles, booked today

The model and serial if you can reach the plate, and if you cannot, how many knobs and how many oven doors. The flat $89 service call covers the trip and the diagnosis.

(213) 516-4020 Book a visit

Visits 8 am to 8 pm, all week · line answered 24/7